Remington MB9100 Heritage Beard Trimmer

ATTACHING AND REMOVING FIXED GUIDE COMBS • Hook the front of the guide comb over the teeth of the trimmer (Fig. A).• Push the back of the guide comb down until it clicks into place.• To remove, lift the tab on the back of the guide comb upwards until it detaches from the trimmer head. THIN OUT AND THINNERS OF BEARDS AND MUSTACHES1. Select the desired comb.2. Turn on the device.3. Place the flat upper part of the trimmer comb against the skin. 4. Slowly run the comb through the hair. Repeat the movement from different directions if necessary. 5. If hair accumulates in the trimmer comb during trimming, turn off the appliance, pull out the comb and brush away the hair. Note: Use the beard trimmer without the guide combs to trim hair close to the skin. This cuts the hair to 1 mm, and if the blades are held at right angles to the skin, the hair is cut to 0.4 mm. You will need a hand mirror if you are going to do this without help.1. Remove the spacer cam.2. In order for the beard trimmer not to cut the hair roots of the hair that you lift up, you should cover them with your index finger. 3. Hold the trimmer with the cutting unit facing upwards towards the neck with the other hand and move the trimmer upwards along the entire length of the neck until it meets your finger covering the hair roots at the scalp.4. Remember to move the device slowly at the same time and to keep the hair roots at the scalp out of the way of the trimmer. CONTOUR MARKING BEARD/MUSTACHES 1. Hold the trimmer with the trimmer blade facing you. 2. Start with the beard/mustache contours and gently lower the trimmer blade against the skin. 3. Move the trimmer in the direction of the beard/mustache contours to trim desired areas of the face. Exclude the beard areas on the neck. SOME GOOD TIPS FOR BEST RESULTS• Beard, mustache and sideburns hair should be dry.• Do not use lotion before use.• Comb the hair in the direction of growth.